I need help from my fellow TPF members regarding rings and diamonds! How do you know a ring is correct for a finger? Esp any finger if it is to be worn on multiple fingers? Should it be tight fitting? Hard an resistant to pull over the knuckle? I used a ring sizer and it said one size but I tried on a couple of smaller sized rings and it fit better! Any expertise opinions or suggestion would be greatly appreciated! Also, which diamond cut do you prefer? Princess or round cuts for a single paved ring? They both looked beautiful but the two rings I looked at sparkled differently! For example, the full paved princess cuts were nicely touching each other side by side. Where as the round cut single paved were faceted and not touching each other side by side like the princess cuts! Thanks.
Ring size & diamond cut?!
- Thread starter CartierLVer
- Start date
TPF may earn a commission from merchant affiliate
links, including eBay, Amazon, and others
Pics? That may help us to advise
Finger size for diamond ring I like it fitted but other rings I don't wear everyday will go slightly looser so easy to take on & off
Finger size for diamond ring I like it fitted but other rings I don't wear everyday will go slightly looser so easy to take on & off
Yes. A picture would help! Sorry bout that! I plan to only wear the ring when I am out an about. Thanks for tip!
Just be aware that if you choose something with pave diamonds 1/2 way or all the way around you won't be able to size it as the diamond would fall out.